Click to select the stairs, then click and drag the move the topmost center edit handle, holding the Alt key on your keyboard or the Option key if you are on a Mac to create a curve in the winder section.This second section will become the Winders, be sure to draw the appropriate number of treads to fit your specific need. Starting at the top of the stairs, create a second stair section, drawing in the same direction as the original.Continue creating landings, reshaping them, and moving them into position until all your winders are completed.Īdding winders using the Staircase Specification in Home Designer Pro The stairs and landing should automatically connect to one another once they are close enough to each other. Using the square edit handle in the middle of the landing, move the landing into position with the stairs.Select the landing and use the diamond edit handles to reshape it into the shape of the winder step.Select Build> Stairs> Landing tool and click to place a landing on your floor plan.Using the Straight Stair tool, draw another section of stairs from where the top end of the winder would be to finish the staircase.Select Build> Stairs> Straight Stairs, then click and drag to create a section of stairs with the number of treads leading up to the winder section.Place the stairs wherever you want them and then you'll see your staircase with winders.Ĭreating stair winders manually using landings.It can be ignored when creating L-shaped stairs. Note: The U-Shaped Stairs section only applies when using the U-Shaped Stair tool. This will split the landing into 2 winders for an L-shaped staircase and 4 winders for a U-shaped staircase. In the New Shaped Staircase dialog that opens, check Make Winders, then click OK. ![]() Select Build> Stairs> L-Shaped Stair or Build> Stairs> U-Shaped Stair from the menu.*Applies to Home Designer 2021 and newer program versions. Adding winders using the Staircase Specification in Home Designer ProĬreating winders automatically for L and U-shaped staircases*.Creating stair winders manually using landings.Creating winders automatically for L and U-shaped staircases*.Winders can be created a variety of different ways: A staircase defined as a winder expands to fill in any gaps between the side of the stairs and nearby walls. Winders are steps located where a staircase turns and are narrower on the inside of the turn than they are on the outside. I have some triangular shaped steps, or winders in my plan. ![]() The information in this article appliesto:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |